




★★★★★5.0 on Google from 170+ reviews
Coloured Concrete in South East Melbourne
Coloured concrete driveways, paths and concrete around the house, with the colour mixed right through the slab. Poured by our own crew from Pakenham. Kobir measures up on site and gives you a written quote, free.
No obligation. We reply within 24 hours.
- Our own crew
- No subcontractors on any pour
- Colour samples on site
- See the real colours before you choose
- Small jobs welcome
- Paths and small areas too
Get a free written quote
Takes under a minute. Kobir will call to book a free on-site measure and bring colour samples.
We pour coloured concrete driveways, paths, steps and concrete around the house for homes across Casey, Cardinia and Greater Dandenong.
The colour is an oxide pigment added to the mix at the concrete plant, so it runs through the full depth of the slab. It isn't a paint or a coating, so it can't peel off or wear through to grey.
Our own crew from Pakenham does every job. Kobir comes out to measure, brings colour samples and photos of finished jobs, and sends you a written quote that names the colour, the finish and how the slab is built.
With coloured concrete, the hard part is getting an even shade from edge to edge. That comes down to how the job is ordered, poured, finished and cured, and that's where we take the most care.
What every coloured concrete quote listsIn writing
- Colour
- The supplier's colour name, chosen from samples
- Finish
- Broom, smooth or a mix, with borders if you want them
- Base
- Compacted crushed rock, depth set for the job
- Slab
- Thickness, strength and steel for a driveway or a path
- Joints
- Where the saw cuts go, planned before the pour
Coloured Concrete Driveways, Paths and More

Coloured concrete driveways
A coloured driveway is the most common job we pour. Charcoal and slate tones suit most new facades on estates in Clyde North, Officer, Cranbourne and Pakenham. A darker colour also hides tyre marks better than plain grey. We build the slab the same way as any of our concrete driveways, with the base, steel and falls listed on the quote.

Paths, side paths and steps
Coloured paths and steps tie the front of the house to the driveway. We give paths and steps a broom finish for grip, and on concrete footpaths down the side of the house we set the falls so water runs away from the walls. Steps are formed one at a time so every rise is the same height.

Concrete around the house and outdoor areas
Coloured concrete around the house gives the whole block one look and keeps the ground drier near your footings. If we're already pouring your driveway, we can do this on the same visit with the same colour from the same plant, so the colours line up.
Coloured, Plain or Exposed Aggregate?
You can mix them, such as a charcoal driveway with an exposed aggregate border or a plain side path. See recent jobs
Coloured concreteColour through the whole slab with a broom or smooth finish. A clean, modern look that matches the house.
Plain concreteStandard grey with a broom finish. The simplest option, and a good fit for long side runs and utility areas.
Exposed aggregateThe top is washed off to show the stones. It has the most grip and hides dirt best; coloured concrete gives a smoother, more even look.
How We Keep the Colour Even
Patchy colour is the most common complaint about coloured concrete. It's almost always caused on the day, not by the pigment. These are the five things we control on every job.
- 1
A firm, even base
We dig out soft soil and lay compacted crushed rock. A base that holds water or settles unevenly makes the slab cure unevenly, and that shows up as darker and lighter patches.
- 2
Steel in the right place
Reinforcing mesh sits on bar chairs in the middle of the slab, where it controls cracking. Driveways get heavier mesh than paths.
- 3
Colour through the full depth
The oxide pigment is batched into the concrete at the plant, measured against the cement, not sprinkled on top. We order the whole pour at once from one plant and one colour, so every truck matches.
- 4
No extra water, one finish
Adding water on site lightens the colour and weakens the surface, so we don't. One finisher works the whole slab the same way, because a different trowel or broom stroke changes how the colour reads.
- 5
Joints and curing
We saw-cut control joints after 48 hours, or about a week in winter, so shrinkage cracks follow the cuts. We plan the joints so a second pour day meets the first on a joint line, and we cure the slab evenly instead of laying plastic straight on it, which leaves dark blotches.
When you compare coloured concrete quotes, ask each concreter how they'll keep the colour consistent. If the answer is just "we use good pigment", the steps that matter haven't been thought through.
How to Choose a Concrete Colour
Suppliers offer a wide range of colours, from charcoal and slate to sandstone and terracotta. Before you pick one:
- match it to something that won't change, like the roof, the garage door or the window frames, rather than the render;
- look at a real slab or a photo of a finished job, not just a small chip. Colour looks darker on a big area and lighter once it dries;
- think about use. Dark colours hide tyre marks and oil but get hotter in summer and show white salt marks (efflorescence) more. Light colours stay cooler but show dirt;
- on a sloping block, ask for a broom finish so the surface keeps its grip in the wet.
On-screen tones are a rough guide only. Names and shades vary by supplier, so Kobir brings the supplier's colour chart and photos of finished jobs to the measure.
How a Coloured Concrete Job Runs
Most coloured driveways take 2–4 days on site, then a week or two before the cars go back on. Paths and smaller areas are usually quicker.
- Before
Measure and colour
Kobir measures, you pick the colour from samples, and you get a written quote.
- Day 1–2
Base, forms and steel
Excavation, removing any old concrete, crushed rock base, formwork, falls and steel.
- Pour day
Pour and finish
The coloured concrete arrives from the plant, then we pour and finish it with a broom or smooth finish.
- After 48 hours
Saw-cut joints
We saw-cut the control joints, or after about a week in winter.
- Day 7–14
Cars back on
You can walk on it after a day or two. Keep cars off for 7–14 days, depending on the weather.
Coloured Driveways and the Crossover
The crossover is the section between your property boundary and the road. It sits on council land, so it's built to the council's standard and needs a council permit, which the property owner applies for.
- City of Casey
- The permit is valid for 12 months.
- Cardinia Shire
- Allows up to 28 business days for approval.
Councils set what the crossover is made of, and that can differ from the colour you choose for the driveway. We check your council's standard before we quote, explain what to put in the permit application, and can pour the crossover on the same visit as your coloured driveway.
Coloured Concrete Across South East Melbourne
We pour coloured concrete across three council areas, all within an hour of our Pakenham base. For everything else we pour, see concreting in South East Melbourne.
City of Casey
- Berwick
- Clyde North
- Clyde
- Cranbourne
- Narre Warren
- Hampton Park
- Lynbrook
- Endeavour Hills
Cardinia Shire
- Pakenham
- Officer
- Beaconsfield
- Nar Nar Goon
- Koo Wee Rup
Coloured Concrete FAQs
Straight answers to what people ask before booking coloured concrete.
Does coloured concrete fade?
The oxide pigment runs through the full depth of the slab, so the colour can't peel or wear through to grey the way a painted surface does. Over the years, sun and weather soften the surface tone slightly, which is normal for any concrete outdoors.
Will it look exactly like the colour chart?
Close, but not identical. Concrete is a natural material, and the shade depends on the cement, the weather on pour day and the finish. That's why we show you photos of finished jobs as well as the chart, and order the whole pour from one plant in one colour.
What are the white marks on coloured concrete?
That's efflorescence: natural salts that come to the surface as the concrete dries. It shows up more on dark colours like charcoal, isn't a defect in the slab, and usually fades over the following weeks and months.
Is coloured concrete slippery?
Not with the right finish. A broom finish gives good grip in the wet, so we use it on driveways, slopes, paths and steps. A smooth finish looks sleek but suits flat, covered areas better.
How much does coloured concrete cost?
It depends on the area, the colour you choose (some pigments cost more than others), the finish, site access and whether old concrete has to come out first. Every job is different, so we don't publish a price list. Kobir measures on site and gives you a written quote, free.
Coloured concrete or exposed aggregate for a driveway?
Coloured concrete gives a smooth, even, modern look. Exposed aggregate shows the stones, has more grip and hides dirt better. Plenty of people combine them, such as a coloured driveway with an exposed aggregate border.
Can you match my existing coloured concrete?
We can get close by choosing the nearest colour from samples held against your existing slab. Older concrete has weathered, so a new pour never matches it exactly. We'll show you the closest option before we start, and a saw-cut joint or border where the two meet helps hide the change.
When can I drive on a new coloured driveway?
You can walk on it after a day or two. Keep cars off for 7–14 days, depending on the weather, so the concrete reaches its strength before it takes a car's weight.
Do you take on small coloured concrete jobs?
Yes. A side path, a few steps or a small area at the back door are all worth a call. If you're planning a driveway later, we can match the colour when you're ready.

Book a Free Measure and Colour Consult
Tell us your suburb, what you're pouring and the colour you have in mind. Kobir will come out to measure, bring samples and send a written quote.